this year for engineering i had to make a can crusher this is my photographic evidence of my completed work.
what i really enjoyed about this project of making this can crusher is how straight forward it was do and complete the can crusher all the parts were relatively easy to make with only problem I had was putting together my parts through welding.
the one problem i had about this project just mostly involved the welding part of it but even so I am glad I did it so due to receiving more experience gas welding and MIG welding.
overall I found this project pretty fun and great to do and found little problems with it I'm happy how my work turned even though I ran through a couple bumps in road while doing it.
Hey Aj, I'm getting a sense that this blog isn't finished yet and i think that you should specify it so readers don't get confused.
ReplyDeleteHi aj, I think you could still put down what you have learnt/done on this project.
ReplyDeleteIt would also look a lot better if you layed it out a bit better it kinda looks all over the place but thank you for saying this blog post has not been finished.
hey Aj
ReplyDeleteyour blog is getting there mate just need some more writing about the project and maybe add a question at the end about how you could improve.
and thank you for saying not finished yet.
Hey Aj, I see that you've just updated your blog. It looks great, can't wait till its done.
ReplyDeleteHey Aj i know your still in working progress but would be nice to see some photos of where your at and also see what youve learnt during the time of making the can cruhser. Also your layout could be more tidy it just looks all over the place. but cant wait to see your outcome of your can cruhser
ReplyDeleteHi Aj i think your blog is of to a good start maybe you could just add some more information about what stage you are up to on your can crusher or maybe even some photos of where your can crusher is at now.
ReplyDelete